Monday, 26 Sep 2022
New 100322

How To Configure Router To Switch In Cisco Packet Tracer

How To Configure Router To Switch In Cisco Packet Tracer. Vlan 10 and vlan 20. Now connect the pc to the ethernet 1.

Packet Tracer Lab 6 CCNA Routing Configure IP from benisnous.com

Display a summary list of the interfaces on the router and switch. The “enable password” sets a password for the privileged mode. Assign a device name to the switch.

First, Add A Router, Switch, And Six Pcs To The Packet Tracer Workspace To Create A Network Topology As Shown In The Image Below.

The “enable password” sets a password for the privileged mode. Physically it looks same network but logically it's different. You can give them custom names.

Now Check Them With “Show Vlan” Command.

Display the routing table on the router. Type config t(configure terminal) to access the configuration menu. Configuring the router in packet tracer.

Change Your Configuration On Your Switch Interface Facing The Router.

Assign a name to a switch. Now connect the pc to the ethernet 1. Select the router and open cli.

Press Enter To Start Configuring Router1.

Switch# configure terminal switch(config)# hostname s1 s1(config)# exit s1# Open the vlan lab and create these three vlan and named marketing, accounting, and sales. Vlan 10 and vlan 20.

Each Router's Interface Represents A Broadcast Domain In Few Words It Is Used For Different Subnets.

Try to test ping from host to gateway (router). After configuring the cisco router’s interface and the tcp/ip settings of the computers, click switch and click the cli tab in the window that opens. Display a summary list of the interfaces on the router and switch.